Omgest

WPS Connection Method

Before we start, there are some conditions that must be met in order to use the WPS push button method:

• The access point must have a physical WPS push button available. Please check with your device’s user guide for details.
  If the WPS push button is not available please use the instructions in the Standard Connection Method section.

• Your network must be using the WPA (Wi-Fi Protected Access) or WPA2 security protocol. Most WPS enabled access points use this protocol.

What about this Canon Pixma Pro-100 Printer? The Canon Pixma Pro-100 Driver is a Wireless Professional Inkjet Photo Printer that allows you to print high-quality paper. With printer Canon Pixma Pro-100 this can help you work primarily for offices and homes, this exquisite type designs that will enable you to place it in a room where You work, here I explain about this type of printer.

Step 1

1. Make sure that the printer is turned on.

2. Press and hold the [Wi-Fi ] button on the front of the printer for a few seconds.

Step 2

1. Make sure that this button starts to flash blue and then go to your access point and press the [WPS] button within 2 minutes.
For exact details regarding pressing the WPS button, please refer to the access point manual.

Canon Pixma Pro-100 Drivers Download

The (blue) Wi-Fi lamp on the printer will continue flashing while searching for, or connecting to the access point. When the printer has successfully made a connection to your wireless network, the blue lamp will stop flashing and remain lit.

Network settings confirmation

To confirm that your printer is successfully connected to your wireless network, you can print out the network settings of your printer if you wish:

1. Make sure that your printer is turned on.
2. Load a sheet of A4 or Letter-sized plain paper.
3. Press and hold the [Resume/Cancel ] button until the power lamp flashes 6 times, and then release it. The network information page will be printed.

When referring to the printout, check that the “Connection” indicates “Active” and that the SSID - Service Set Identifier (the name of your wireless network) indicates the correct name of your wireless network.

This concludes the WPS setup procedure.

Please now proceed by installing the software to make the most out of your PIXMA PRO-100.

If you do not have the installation CD that came with your product, please download the manuals and software to continue.

Canon Pixma Pro-100 Setup Mac

If the wireless setup is still failing after following this guide, please contact us for further assistance.